ACT-3X recording tachometer MONARCH

ACT-3X recording tachometer MONARCH is a powerful, fully programmable tachometer and totalizer calibrated for NIST. It accepts input signals from all Monarch speed sensors or any standard TTL generating device. The device works with 120 / 240Vac input power supply or with 12 or 24Vdc input power supply (optional). Programming can easily be done using the 5 buttons on the front panel or using the free PM Remote software to download. Configured to monitor a single channel. Programmable scale factor with menu selection for multiple pulses per revolution, linear speeds, summation, single event activation speed (using the auxiliary input) and speed of changes in rpm. TTL pulse repeater output is standard. Recommended sensors with PN-W (= tin wires), ROS-W, ROS-HT-W-25, P5-11, M-190W, IRS-W, ROLS-W, SLS-115/230 and GE gas engine 200 (with an amplifier).

Click here and check all fixed mounted tachometers by Monarch Instrument.

Additional information

Zakres prędkości	5 to 999,990 RPM (single pulse per revolution), 0.5 to 999,990 RPM (10 pulses per revolution). Speeds below 5 RPM are possible with multiple pulses per revolution
Accuracy/Resolution
Rozkład	Up to 0.001 RPM, 10 RPM (100,000 to 999,990 RPM).
Display	5 digit, 0.56" (14 mm) high red LED.
Aktualizacja wyświetlacza	Menu Selectable between: 0.5 second above 120 RPM, 1 second above 60 RPM and 1.5 seconds above 40 RPM.
Moc wejściowa	Standard: 100 – 240 Vac +/-10%, 50/60 Hz, Optional: 12 or 24 Vdc +/-20%, Isolated, 8VA
Wejścia	Universal input for optical, proximity, two wire or three wire magnetic, infrared or laser sensors. TTL input or 3.3 Vac to 50 Vac input. Standard input is 1 pulse per revolution.
Wzbudzenie czujnika	5Vdc or optional 12Vdc or 24Vdc to sensor.
Zalecane czujniki	Optical – Monarch ROS-W, ROS-HT-W-25, ROSM-5W Proximity – Monarch P5-11 Magnetic – Monarch M-190W or MT-190W Infrared – Monarch IRS-W Laser – Monarch ROLS-W, SLS-115/230 Inductive – Gas Engine GE-200 (requires amplifier)
Wyjście przekaźnika impulsowego (opcjonalnie)	Standard, 0 to 5 V TTL compatible. One pulse out for each pulse in. Menu selectable polarity.
Wyjście analogowe (opcjonalnie)	Voltage (AO): 0 to 5 Vdc, 5mA max load (isolated or non-isolated) or Current (IO): 4 to 20mA, 500 ohm,¦ max load. (isolated or non-isolated), 1 to 5Vdc possible using 250 ohm resistor) 16 bit resolution. Front panel push button programmable for full scale and offset RPM ranges.
Programowanie zdalne	Unit can be remotely programmed using optional communications interface and PM Remote Software.
Otoczenie	Indoor use only, Installation category II per IEC 664 Temperature: -10 degree C to 50 degree C operating per IEC 61010-1 Humidity: Maximum relative humidity 80% for temperatures up to 31 degree C, decreasing linearly to 50% relative humidity at 40 degree C.
Bezpieczeństwo elektryczne	Meets EN61010-1:2001, EC low voltage directive 72/23/EEC and 89/336/EEC